Top Ranked Tips For Concrete Polishing
The polishing industry is one of the industries that have risen up rapidly. The companies that are growing and those that are coming up now are too many in this industry. With time, many other companies will keep coming up due to large population getting interested in this industry. The article has tips that can be applied by the companies to ensure there is good concrete polishing done. These tips are explained in this article.
The first tip of concrete polishing is to determine the surface hardness. This is done by testing its hardness using a concrete hardness tester. This helps in the selection of the abrasives. The tip number nine is the one used for scraping first. Then the scratching is done in a descending order. This is done until the tip cannot do the scratching anymore. This is the level where the hardness is ok.
Then the concrete surface is then prepared. Some floors for concrete polishing are coated. Then the right equipment is used to remove the coating. The type of coating is what affects the equipment to be used in the removal of this coat. Holes and cracks can be found in some floors that need to be polished. The repairing of this holes and cracks should be done first. The next thing that should be done is gritting with the metal bond tooling to the level and flatness that is desired.
Then the metal tool marks have to be removed. This is done through the use of transitional tooling. The ability of transitional tooling to eliminate all the marks is high. The process is considered successful when all the tool marks disappear.
Then densifying and hardening of the floor is done with the process of vacuuming. The floor is densified and solidified by the pore and crack filler. It helps avoid water penetration that can result in stains that can result due to water penetration. A lot of care is needed so as the pooling does not result when using the floor densifiers. This is because the stains caused by poling can result to the stains that can make polishing hard to do.
Then now the polishing is done after all the above things are complete. Resign band tooling is appropriate to start with. Then all the dust is removed that is, the space is vacuumed in between the passes. Then the floor is burnished with a burnishing pad after the final grit level is achieved.
Then for protecting is done as the last thing. The protection is done by sealing the floor. Some of the things that the floor is protected from are the grease, oil and any other chemicals. The sealer can be applied with the use of a pump and allowed to coat. To leave the floor shining, burnishing is essential. These are the best ideas that can allow successful concrete polishing.