Getting To The Point – Plates

Tips on How to Install a License Plate

It is prohibited to drive without a license plate as you are said to be a lawbreaker. As a result, you become a wanted person by the police when they spot you driving without a license plate. Having a licensed plate installed to your car therefore, becomes a necessity. Therefore, you must know how to mount a license plate. Taking every tool that you will require in the whole process becomes your first step. The required tools comprise of, the correct screws, the validated sticker and the screwdriver which is flat-headed.

The next step relies on whether are renewing the license plate or if the car is being installed the license plate for the first time. It is useless to drill other holes if your car had a license plate before. If you are still using the expired license plates, you remove them and clean the place in preparation to attach the new validation tag. A screwdriver may be of use when you are prying off the old sticker. The new sticker is put at the top corners of your license plate. You line up the license plates with the holes in the already drilled car and screw the plate using a screwdriver. You should ensure that the plate is not that tight. When mounting the license plate for the first time, it becomes essential to drill holes. You should ensure that your bumper is made of fiberglass. You measure to find the center of the bumper using a measuring tape and mark the area with a pen. You place the license plate at the center point and mark the points where to drill holes. You then drill the holes which are shallow and repeat the above procedure.

There is also an alternative for those who are not ready to drill holes in their bumper. You buy an adhesive-mounted bracket that fits the make and model of your car. You are supposed to clean up the area with rubbing alcohol for the adhesive to stick properly. After the bumper has dried, you try fitting the bracket with its protective film on. After fitting, you remove the protective film at the back of the bracket and place the bracket onto the bumper. Using a screwdriver, you attach the license plate to the bracket using the screws. This method should be used by people whose car’s bumper is made of metal and have never drilled holes again. This is because drilling in a metal front bumper is somehow complicated.

More info about how to install a license plate can be obtained online.